Firmware June/25

Important note:

Always load the monitor firmware before the system firmware.
The system firmware contains the runtime firmware – this does not normally have to be loaded separately.
Only in case of a newer runtime firmware it can be loaded separately.

ftpReceive could sometime fail with a partially transferred file.
gsmPower could hang if the APN was incorrect.
GPS week-rollover on RTCU MX2 turbo / encore devices from 2014.
The rollover will occur on 29/10-2022 0:00 and again on 16/8-2025 00:00.
Serial-numbers impacted: 291444xxx, 291450xxx, 292415xxx, 292428xxx, and 292442xx.

requires System-firmware V1.09.00

Support for up to 5 simultaneous MQTT connections.
GNSS support for BeiDou on the RTCU NX-200 DR
Support for VoLTE: gsmVoLTEEnable() and gsmVoLTEStatus()
Adjustable Modbus TCP connection timeout: modbusOpenX()
Improved Modbus communication performance.
A new function block to retrieve statistics for a given network interface: netGetStatistics.
Optimized/faster data connection establishment.

NX-200 series: Unstable execution with intermittent kernel crashes (fault code 205).
When the cellular engine was OFF, gsmSIMPresent() did not work.
mqttClose() could crash the runtime (fault code 200).
RDS Directory Synchronization did not work.
Problems connecting to LTE with certain SIM cards.
pmPowerDown() and PowerDown() did not resume when power was applied during the call.
Memory based datalogger did not work when writing an entry with a size less than the record size.
Datalogger written to file with logSaveToFile() could sometimes not be opened with logOpen().
sockConnection sometimes did not work correctly over an interface close/open.