M2M Control Upgrade & Deployment Server

The M2M Control Upgrade & Deployment Server (UDS) is a server based middleware solution for maintaining application software and firmware remotely. Especially for a large scale installation of M2M Control devices to handle the device and software management automaticlly.

The Upgrade & Deployment Server can be configured by the user to insure that groups of specified units are operating with the correct firmware, application software or a generic files. The UDS will automatically insure that the units are upgraded as requested and this task will even take place during FULL operation of the unit. Any interruption in an the upgrade attempt will be automatically handled and resumed to avoid any waste of expensive bandwidth.

The Upgrade & Deployment Server uses the M2M Control GPRS Gateway for the communication with the units. So the software downloads are done remotely thru the GPRS connections of the moble network (Firmware-Over-The-Air FOTA).

 

Advantages:

  • automatic device and software management
  • maintaining application software and firmware remotely
  • FOTA: Firmware-Over-The-Air
  • management of large scale installations

 

 

  • Uses the M2M Control GRPS Gateway to establish a connection to remote units.
  • Runs as a Windows Service for automatic start-up in server installations.
  • Available in a 32 bit and a high-performance 64 bit version.
  • Remote maintenance, diagnostic and logging facilities.
  • Upgrades firmware and application automatically according to user-configuration.
  • Firmware and application can be upgraded during full operation of the unit.
    This unique feature minimizes downtime and the impact on the user.
  •  Failed upgrade attempts will automatically be resumed at the point of interruption.
     This unique feature will reduce the cost and time of upgrading.
  • Automatically or application driven decision when to switch over to the new application/firmware.  All that is required to switch over to the new firmware/application is a reset of the unit, which will only interrupt 
    the operation for 10-20 seconds.
  • Up to 200 simultaneous upgrade sessions.
  • Support applications that use VPL upgrade notifications.
  • Support for automatic programming of un-programmed factory delivered units.
  • Scheduled upgrade policy.
  • Support for upload of user defined file to unit.
  • Comprehensive logging and status features.
  • Import from and export to comma delimited files.

 

System requirements:

  • Pentium-class 2 GHz or better
  • Windows 8/Windows 7/Vista/2003 Server/2008 Server/2010 Server.
  • Minimum 2 GB MB RAM
  • Minimum 50 MByte available space on hard disk.
  • permanent internet connection with fixexd IP adress

 

 

Unterstützte Produkte:

  • M2M Control C310 eco
  • M2M Control C350 pro
  • M2M Control C450 pro
  • M2M Control C510
  • M2M Control C550
  • M2M Control C600 pro
  • M2M Control C610 eco